AUTOCIRC with adjustable thermostat
A modified Autocirc ® 353 with adjustable thermostat. The band width of the thermostat is adjustable to induce the pump to operate more frequently. This reduces the 'off' time, thereby reducing the temperature drop in the exposed hot water pipe between cycles, thus maintain a higher water temperature.
It's thermostat is adjustable between 30 and 35oC with all other aspects of the pump including installation are identical to the ACT353BTW.
With this pump we will ensure that you no longer have to watch your water go down the drain while you are waiting for it to heat up. The water will be instantly hot and will cost the average home a mere 90c to run per month. Easy to install, Autocirc is the best solution for an existing home that would like to take advantage of having instant hot water on tap all the time. This version of the Autocirc pump also includes an adjustable thermostat.
TYPICAL INSTALL
The Autocirc is installed underneath the sink and requires only a single power point to operate. Installation is simple, just disconnect the pipes to the two taps, connect the pump and reconnect the pipes from the taps to the pump, set the timer and the jobs done.
The autocirc is not affected by the tempering valve, in fact when connected to a system using a tempering valve, it is even more economical. The Autocirc will pump through most non-return valves, however it cannot pump against a pressure gradient. If there is a pressure reducing valve immediately before your water heater, or between the cold water take-off and the water heater, this pressure reducing valve must be moved back to before the cold water take-off. Autocirc requires that both the hot and cold water pipes in the house be at the same pressure.
This product was added to our catalog on Tuesday 21 August, 2007.
